If Walls Could Talk
May 12, 2006
Over all photo of piece titled "If Walls Could Talk."
Close up of hammer and saws in 2×4's.
Photograph of installation from main floor.
Close up of the ultra-sonic sensor used to detect viewer coming out of the toolbox, used to activate the hammering and sawing sounds.
The inside of the toolbox. The CD player is connected to the 4 speakers used to built the sound needed. The CD player is controlled by a programmed Logo chip and runs on AA batteries.
What you see here is one of the two speakers covered up with saw dust from the saws. You may see a few nails here and there dropped from the work area above.
Close up of the arrangement of the actual hammers, saws, 2×4's, and nails used.
